Pass Authentic Cisco 300-425 with Free Practice Tests and Exam Dumps
New 300-425 Exam Questions Real Cisco Dumps
NEW QUESTION # 49
A network engineer is working on a design for a wireless network that must support data, voice, and location services. To support these services, which access point placement must the engineer use?
- A. indoor and outdoor
- B. perimeter and corner
- C. perimeter only
- D. corner only
Answer: B
Explanation:
NEW QUESTION # 50
What is the minimum recommended RSSI for designing a WLAN to support data applications?
- A. -67 dBm
- B. -75 dBm
- C. -70 dBm
- D. -80 dBm
Answer: C
NEW QUESTION # 51
Which two considerations must a network engineer have when planning for voice over wireless roaming? (Choose two.)
- A. Roaming occurs when the phone has reached -80 dBs or below.
- B. Full reauthentication introduces gaps in a voice conversation.
- C. Roaming with only 802.1x authentication requires full reauthentication.
- D. Roaming occurs when the phone has seen at least four APs.
- E. Roaming time increases when using 802.1x + Cisco Centralized Key Management.
Answer: B,C
Explanation:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/vowlan/41dg/vowlan41dg-book/vowlan_ch5.html
NEW QUESTION # 52
Which three pieces of equipment are needed to conduct a fully measured wireless survey? (Choose three.)
- A. access point
- B. tall tripod
- C. spirit level
- D. PoE battery
- E. ladder
- F. goggles
Answer: A,D,E
Explanation:
A fully measured wireless survey requires tools that support the active functioning of the network and allow for physical access to install and measure equipment. A PoE (Power over Ethernet) battery is necessary to power the access point during the survey. The access point itself is essential for broadcasting the signal. A ladder is needed to reach high places for proper access point placement and to measure coverage areas effectively.
References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide
https://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/81/design/guide/b_mesh_81/Site_Preparation_
NEW QUESTION # 53
When designing for high-density environments such as stadiums, which is MOST important?
- A. Use of omnidirectional antennas
- B. Use of directional antennas with sectorization
- C. Deploying APs only on 2.4 GHz
- D. Increase transmit power of APs
Answer: B
NEW QUESTION # 54
A network engineer is configuring high availability on an access point. What is the maximum number of controllers that can be configured?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
Explanation:
Explanation
So max 2 will be supported on an AP.
NEW QUESTION # 55
A network engineer must design a new wireless solution for a company, but the budget can only stretch to include a single Cisco 9800-40 WLC. The company requires high availability between the WLC and the core switch in the event of a cable failure. The WLC must dynamically manage port redundancy and perform load balancing between APs transparently. Which design approach must the engineer take to meet the requirements?
- A. Multi-LAG
- B. LACP
- C. LAG
- D. PAgP
Answer: C
NEW QUESTION # 56
An engineer is designing a wireless deployment for a university auditorium. Which two features can be used to help deal with the issues introduced by high AP count? (Choose two.)
- A. LSS
- B. RXSOP
- C. DFS
- D. TSPEC
- E. TPC
Answer: C,E
Explanation:
https://www.cisco.com/c/en/us/support/docs/wireless-mobility/80211/200069-Overview-on-802-11h-Transmit-Power-Cont.html
NEW QUESTION # 57
Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?
- A. When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.
- B. When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
- C. When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
- D. When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.
Answer: C
Explanation:
NEW QUESTION # 58
What is a key benefit of using a GRE tunnel to provide connectivity between branch offices and headquarters?
- A. Less overhead
- B. Authentication, integrity checking, and confidentiality
- C. Open standard
- D. Granular QoS support
- E. Scalability
- F. Dynamic routing over the tunnel
Answer: F
Explanation:
Generic routing encapsulation. Tunneling protocol developed by Cisco that can encapsulate a wide variety of protocol packet types inside IP tunnels, creating a virtual point-to-point link to Cisco routers at remote points over an IP internetwork.
NEW QUESTION # 59
An engineer is conducting a Layer 2 site survey. Which type of client must the engineer match to the survey?
- A. normal client
- B. phone client
- C. best client available
- D. worst client available
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/116057-site-survey-gu
NEW QUESTION # 60
A wireless network consists of:
* two IOS XE controllers installed in a data center
* 9100 series APs
* corporate and a guest WLAN
The customer must high availability pair two Cisco WLCs for the client SSO. Which two design approaches must the engineer take to meet the requirement? (Choose two.)
- A. Both WLCs must have the same redundancy management IP address.
- B. The controllers must have the same number of licenses.
- C. Both WLCs must have the same service port IP address.
- D. The controllers must run the same operating system version.
- E. Each WLC must have a unique redundancy management IP address.
Answer: B,D
Explanation:
For high availability pairing of two Cisco WLCs for client SSO, it is essential that both controllers have the same number of licenses to ensure feature parity and seamless failover. Additionally, they must run the same operating system version to avoid compatibility issues during SSO operations.
NEW QUESTION # 61
The wireless survey report shows APs staggered throughout a facility, with several of them placed on the exterior walls. Other APs are located at building corners and major turns in the structure layout. Assuming that all survey locations are optimized with a minimum of -67 RSSI at cell edges with 20% overlapping cells, for which purpose is this survey model used?
- A. voice, data clients, and video on demand
- B. location-based services, BYOD preparation, and HD video streaming
- C. streaming video with VoIP, data, and HD resolution
- D. location services, VoIP, data, and video
Answer: D
Explanation:
The survey model described is used for location services, VoIP, data, and video. The placement of APs on exterior walls, building corners, and major turns helps ensure consistent coverage and signal strength for a variety of applications, including precise location tracking and high-quality voice and video communications. References: Designing Cisco Enterprise Wireless Networks (ENWLSD 300-425)
NEW QUESTION # 62
An engineer must ensure that the new wireless LAN deployment can support seamless roaming between access points using a standard based on an amendment to the 802.11 protocol. Which protocol must the engineer selects?
- A. 802.11r
- B. 802.11ac
- C. 802.11e
- D. 802.11i
Answer: A
Explanation:
NEW QUESTION # 63
WLC SSO is set up between two WLCs in a service provider network serving public spaces. On WLC failover, it is noticed that only about half of the original client count is now showing on the secondary WLC, although it is currently showing the role as active.
Which design side case explains the issue?
- A. Some client sessions were in WebAuth-Req state before failover.
- B. The secondary WLC platform does not support the required client count.
- C. SSO is not configured correctly.
- D. The WLCs had not completed database sync before the primary failure.
Answer: A
NEW QUESTION # 64
What is the recommended cell overlap when designing a wireless network for Cisco Hyperlocation?
- A. 40%
- B. 30%
- C. 20%
- D. 50%
Answer: C
Explanation:
NEW QUESTION # 65
An engineer has configured guest anchoring for a newly created SSD however, the mobility tunnels are not up, and EPING is failing from the foreign WLC to the anchor WLC. Which traffic flow must be allowed at the firewall to enable the communication?
- A. IP protocol 97
- B. UDP port 97
- C. TCP port 97
- D. UDP port 16666
Answer: A
Explanation:
NEW QUESTION # 66
Refer to the exhibit. A customer is deploying a Greenfield 802.11n network with data, voice, and location awareness using APs with the WSSI modules. Which two settings in the Cisco Prime Infrastructure Planning Tool, when selected, provide a more accurate prediction of the number of APs the customer must purchase for the new facility? (Choose two.)
- A. Location
- B. Location with Monitor Mode APs
- C. Voice
- D. Override Coverage per AP
- E. Data/Coverage
Answer: D,E
NEW QUESTION # 67
An engineer must decide the cell overlap for a wireless voice deployment. Which Cisco measurement recommendation should be considered?
- A. The measurement should be done on the 2.4-GHz band.
- B. The edge of the cell should be below 35 RSSI.
- C. The edge of the cell should be -67 dBm.
- D. One AP should be deployed per 3000 square feet.
Answer: C
Explanation:
NEW QUESTION # 68
......
Cisco 300-425 exam is a 90-minute test that consists of 60-70 questions. 300-425 exam is available in English and Japanese and can be taken at any authorized Pearson VUE testing center. The test is computer-based and requires a passing score of 750 out of 1000 to obtain the certification.
Conclusion
The Cisco 300-425 exam intends for you to master practical issues around wireless networks, and specifically those associated with the enterprise. Training and guidebooks are present to build your potential in this key sphere. So, anyone looking around for a beefing up of their skills in the sector should see to them that he or she takes and passes the actual test with ease.
300-425 Exam Info and Free Practice Test Professional Quiz Study Materials: https://braindumps2go.actualpdf.com/300-425-real-questions.html
